i have Jtagged my console and falshed the xbr_3a for somedays.it works well until i changed the original 60GB HD to a new 320GB HD yesterday.in order to transfer my savefiles and other files ,i have to open the driver and link to my PC.but when i finished and get the 320GB on,1 red lights with E79...........
BUT,when i unplugged power cable and then plugged in,the console was running without error.but i have to set language and region .after this ,it works fine.
when i turn the power off,and next time i want to use it,1 red lights,yes,AGAIN.....
and after i unplugged power,then plugged it.it runs well , but i have to set the configure ,AGAIN....
what's wrong with it
??what should i do?
Your JTAG is most likely loose. Ive had this happen to one console I JTAG'd. It would forget the settings on next boot so I opened it up and I just resoldered the wires and it booted fine everytime since then