Print

[chorizo1]

THIS IS NOT A LT THREAD - keep theories etc. elsewhere

[swiebie]

QUOTE(xboxer360 @ Dec 10 2009, 03:09 AM)

top left corner, second and third pins from the right.
even if you lift the pad, it's not hard to join pin 101 back to a 3.3v source. in fact the drive still works without it, you can lift both pins 101 and 122 and it still works, heck it works even with 1.8 lifted too

Why do we need to make a hardware workaround while the xbox can see the drive ID by the cable?

[hawk_dsl-komi]

liteon 83850c v2. After soldering/cutting, flash was reading with DosFlash 1.8 without troubles (resistor 21OHM). Read and save flash three times =) bin image was loading in JF, key seems to be valid. After reconnect lines - insert key in 83v2 f/w template and write it with JF. Without errors. Then turn on box with flashed drive - only see "Play DVD" then insert any game disc (backup or original). After that I'm trying all f/w - LT 7, 8v2, 9, write it with DosFlash and JF, insert key into BenQ f/w and write it on benq drive - it can't read games too.
For test wrote dumped firmware without changes - after that drive can't recognize in 360 - it stuck on main logo. How can it be - bad flash but no one software tool cant see that? Keys and serials are indentify in all 3 dumps. But - serial in JF (in inquiry/identify/drive serial) is 17 chars + "!" + two spaces. If in manual spoof chooses any liteon (7 or at "spoofed as", error is pop up - serial must be 17 chars and three spaces. One point to bad dump? I don't want to believe....

[Zoneout]

QUOTE(xboxchan @ Dec 11 2009, 07:33 AM)

this is all the info on my board:

DVD ROM   REV:01
68S32G16D2SC01X
E74739
94V-0
SUNG WEI 88V0A

BS-1

4-r-P
F/W93450C-2
M15
5B13400126V01
S4P9930000
0014605238

2090826D
has anyone done one like this before?

Works fine for me, September 2009 93450C-2.

[pappi76]

QUOTE(pastortom @ Dec 8 2009, 08:57 PM)

Aight, great..

But atm, Im only getting status 0x51 and 0x52 when I turn it on with the switch on..

I even try with the dvd-drive tray ejected half way out..

Nothing works..

no 0x72 =/ MTK vendor intro fails..

But it reckognizes the drive as a 93450c firmware revision and Liteon.. but the MTK Vendor Intro fails..

Now, the only possible two reasons Im left with is either:

1) the resistor Im using is wrong (ive measured it at 20k and it shows as 2.21, which Im pretty sure is 20 ohms)

2) the PIN101 is not properly cut away from the line above.. (AND HERES THE THING.. Ive cut it, and Im 99% certain its cut, probably cut it 15 times, and it looks 100% cut, but still my multimeter shows it as still connected to the line above)..

HALP?!