Topic: 16mb Jasper Having Issues With Xell (Read 85 times)

jaygriggs · « **on:** January 27, 2011, 09:48:00 PM »

Here's my situation

Im using the nand x and coolshrimps tool the newest version 12611
I used the alternative jtag wiring aud and then connect to the dvd drive wire by using this tut
http://team-xecuter....ead.php?t=55189

If I use the tool and tell it to write xell or xellous the xbox goes dead when I try boot.

Last night I followed another tut to build a xbr image

The console booted however it did not boot xell when I pressed the eject button no matter what jumper settings I tried.

Could my jtag wiring be bad?
Should I try creating another image with different options?

I guess Im just looking for the next steps I should take.
Sorry for bein such a noob and thanks in advance for any guidance.

jaygriggs · « **Reply #1 on:** January 30, 2011, 08:11:00 PM »

I believe so and I have tried a few as well. I just have this feeling like Im missing something simple.

http://team-xecuter....mp;postcount=22
After reading this post I tried this file but it gave me a e 79 error maybe I need to try again

original nand= boots just fine
xbr = boots but no xell
most of the time when I write xell = dead console

jaygriggs · « **Reply #2 on:** January 31, 2011, 05:17:00 PM »

when I try to boot xell or xellous I get a dead console no lights nothing. Wont turn on with the power button, eject or controller. If I write the original nand it comes back to life like nothing happened.

I have one bad block at 359 but nandhealer said its ok

I used this wiring
http://team-xecuter....ead.php?t=55189

But at this point im thinking about undoing it and going with the original points the db1f1 and rol
I also have the nand x qsb in place

At this point im starting to question that too but it looks clean

jaygriggs · « **Reply #3 on:** January 31, 2011, 06:05:00 PM »

Switched the jtag wiring to the original wiring, wrote xellous manually it booted no problem

Thanks for all your help
I dont know if I should be extremely happy or extremely pissed

Wompa164 · « **Reply #4 on:** February 01, 2011, 08:32:00 PM »

When you flash Xell, you need to accompany it with a patched SMC. Otherwise, Xell will boot using the standard SMC, looking for signals on argon_data + DB1F1, and won't find it since you're using aud_clamp wiring.

Author Topic: 16mb Jasper Having Issues With Xell (Read 85 times)