Print

[niai]

you need to use switching diods for jasper not resisters if you haven't installed it yet i would suggest using xbr as its simple easier and more supported and sell your cygnos

diagram


but if you are keeping the cygnos i am not shore as i have not done it but i think jtag is part of the x1-7 points on the cygnos

[HooGLaNDeR]

QUOTE(dokworm @ Jan 3 2010, 04:29 PM)

Actually it turns out you don't need the resistors at all.
Basically you install the Cygnos without the jtag points connected, flash it to ver 1.03 firmware and *then* connect the jtag points without using resistors or diodes.

Can you post your pics of the mod?

[dokworm]

QUOTE(HooGLaNDeR @ Jan 4 2010, 11:48 AM)

Can you post your pics of the mod?

I only put it all back together last night, I didn't take any pictures.

But basically you just solder in the Cygnos V2 and hook up *all* of the wires on the bottom but not the ones on the top. I then flashed the Cygnos with ver 1.02 and then 1.03 firmware, and then just hooked up the top motherboard wires directly without resistors or diodes. I then threw a 320GB drive in my old 20GB drive enclosure and formatted it and can use all 320GB - excellent.

I'm hoping to find another exploitable box, will take photos when I do that one.