Good afternoon,
I've done some research and talked to some people and still am unsure about this issue...
here's what I dd...
1. installed my solderless x-bit
2. installed a new 120gig HDD
3. flashed my chip
3.1 used the x-bit program
3.2 flashed the m7 bios with the eject fix into the bank 6 bios 6 of the x-bit prog.
4. set my dip switch to read bios 6
5. inserted the Slayer auto-install v2.5
6. turned off xbox rebooted
7. using option 3-1 on the evolution x dashboard I formatted my HD
8. turned xbox off
9. turned it back on and the xboxdash borad comes on instead of the evolution x one.
You can actually see the bios in the slayer evox dashboard when I run the boot cd. I've read that all the bios spaces in one bank found on the x-bit program had to be filled... either with the same bios or different ones .. I've only got the bios 6 in bank 6 filled could this be the problem?
I've read on modifying the ini file but didn't think was required with the auto installer.
Thanks again