Topic: Flashing Accident (Read 20 times)

petedeadly · « **on:** December 22, 2005, 02:42:00 PM »

I have an xbox which i just chipped and I used the flashing guide on this website to load flash. All seemed to go OK and I got the progress bar up and xbox shut down when complete. However, when I restarted, the boot up is all wrong. It powers on and off a few times and then the LED flashes red. Theres nothing on screen and the only way i can get back to normal is to switch off the chip.

Is there a way to start again or have I buggered the chip now?!!

greenday54261 · « **Reply #1 on:** December 22, 2005, 02:44:00 PM »

What chip? You may be able to hotswap the chip to get the flash back. Find a friend with the same type of chip, use it in your box and boot to the flashing screen. Then swap the chips and reflash the bad one.

MMXMonster · « **Reply #2 on:** December 22, 2005, 02:55:00 PM »

More info required...

Version of Xbox
Bios flashed
Modchip used

greenday54261 · « **Reply #3 on:** December 22, 2005, 02:56:00 PM »

And don't make more than one of the same topic. I posted in your other one. A moderator is probably going to merge these two together soon.

petedeadly · « **Reply #4 on:** December 22, 2005, 03:16:00 PM »

Sorry, the duplicate topic was accidental.

XBOX Version: 1.4
Modchip: Xecuter 2.6ce
Bios: 5035 xecuter2

I used X2 bios manager to create the bios image

jameswalter · « **Reply #5 on:** December 22, 2005, 03:29:00 PM »

Did you try to make the X2-5035 a 256k bios?

petedeadly · « **Reply #6 on:** December 22, 2005, 03:36:00 PM »

No i made it 1024k and put a 60mb dummy file on the disk.

Author Topic: Flashing Accident (Read 20 times)