Print

[bertrenolds5]

I just got a programmer because I accidentally had a bad flash through the xbox. I pluged the chip in then the battery and then connected it to the printer port.  I open up XP.exe and scan and find my chip, I can see that it is set up with 4x256 and I can read most of the banks but some times get and error reading modul! warning then I press ok. I get the Same error when I try to flash a bios to the chip. I have been able to read 2 banks before getting an error. I get the blue led when I select scan also so I know its working. Is this a chip problem or a programmer problem. I'm pretty sure the chip is fine but I'm not sure if  programmer is because I bought it off someone here in the forums. Any suggestions would be welcomed.