I made paper models of all of the mobo, hd, & psu. I placed em where they're going, and snapped some pics so you guys can see the plans so far.
The back board with the mobo on it is going to be set on hinges, with the wires from the mobo close to the left (looking at it from the back) side of the amp, so the door can open. It's going to have a little screw that comes out on it on the right side of the door that you pull on to open the door. Everything else is pretty self explanatory.
But I just ran into the problem, that the HD, in order to fit in there properly, has to go against that black board, which i was planning on taking out (look at the pics), but now i have to leave it in for the HD, and the HD will be blocking the airflow.... hmm... I'll have to think about it...
Note: in the pics, the back board with the mobo on it, is upside down, the mobo will be rotated 180 degrees.
Tell me what you think...
-Danny