Print

[Exobex]

From http://www.jungleflasher.net/194.html

JungleFlasher 0.1.94(320)

========================================
Support for new Key verification process
Vendor command support for DG-16D5S Drives
-xecuter X360USB Pro ***f/w update required***
-xecuter X360USB Pro 2 ***f/w update required***
Extra functions to utilise RGH extracts with LTU using T-X DG-16D5S replacement PCB

Support for LT Plus 3.0
-Hitachi 78, 79

Support for LTU 1.2, using T-X replacement PCB
-liteon DG-16D5S 1175, 1352
-liteon DG-16D4S 0225, 0401, 1071 - lost f/w replacement, replaced with a T-X DG-16D5S replacement
-hitachi DL10N 0500, 0502 - replaced with a DG-16D5S

Bug fix to SlimKey for bytes at 3f005, 3f006

IO port enumeration for Win 8 using old school PCI bus scan
-Using new portIO driver from schtrom with 32bit memory access

From http://www.xbins.org...xboxnfo2295.nfo

C4E's iXtreme LT Ultimate in association with Team Jungle & Team Xecuter
------------------------------------------------------------------------

Official release of the iXtreme LT Ultimate for Team Xecuter LTU PCB

- Support for Liteon 0225, 0401, 1071, 1175, 1532, Hitachi 0500/0502

- No need for firmware dump of source drive. Requires dvdkey and J-Runner data

- Supports enhanced topology data if present for more accurate topology responses (Future ABGX support)
 
- Requires new JF to support LTU board flashing process. Use 0800 dual layer disc in drive to enable reflashing/vendor mode once LTU is written to board

This firware is uniquely written for the TX LTU board. It has all the features of LT 3.0 with the addition of the LTU features.
The 1332 chip has been the most secure chip used in the 360 to date. Cudos to MTK/Liteon for their attempt.
The movement of the dvdkey, AES routines and realtime firmware checks into the drive CPU was a nice touch.

I would like to dedicate this release to fellow countryman and Commodore hacker Julian Assange and Wikileaks. Keep the bastards honest.

Thanks go to Team Jungle and all testers for their hard work and efforts in the development process.
Thanks also go to Team Xecuter for their support to this project.

[Exobex]

If you've got a LiteOn DG-16D5S (1175, 1532) you will need:

1) A T-X LTU replacement PCB
2) An RGH mod so that you can retrieve the key


If you've got a Hitachi DL10N (0500, 0502) you will need:

1) A T-X LTU replacement PCB
2) An RGH mod so that you can retrieve the key
3) A LiteOn DG-16D4S or DG-16D5S to put the PCB in (it won't fit the Hitachi)

[fozzieb]

I have a corona v2 board with a 1175 liteon 16D5S

Am i correct in thinking that i will need to install the corona 4Gb nand R/W to do a nand backup

Then install the Xecuter DGX v1.0S Slim to get the keys

Remove the Xecuter DGX v1.0S Slim

Flash the new FW to the replacement TX PCB .

There are lots of guides for all the various steps but no one complete guide for my setup.


Cheers