Topic: Tsop Semi-messup (Read 33 times)

imamafackinhokie · « **on:** October 19, 2004, 03:58:00 PM »

Ok I installed a switch on a 1.0 and booted up and did a mechassualt exploit then flashed the tsop with a 512 kb switch. The thing is the switch was in the off position and I thought i had it on. I can boot using the x2 bios i put on to a dashboard, but i cant boot at all with the m$ bios. What i am asking is how to i go about reflashing the m$ bios, should it be 1 mb when i reflash it with the switch off in evox or should it be something else?

lordvader help me out here

imamafackinhokie · « **Reply #1 on:** October 19, 2004, 05:35:00 PM »

Any advice?

This post has been edited by imamafackinhokie on Oct 20 2004, 12:37 AM

acemilo · « **Reply #2 on:** October 19, 2004, 06:10:00 PM »

You have 2 choices. You can boot up the xbox, then when you go to flash it just switch it over to the other bank and reflash it with a 512, or turn on the xbox, disconnect the switch (alternatively you can cut the wires first and twist the 2 wires together to boot then untwist) and flash the bios with a 1mb with half x2 and half retail.

imamafackinhokie · « **Reply #3 on:** October 26, 2004, 01:43:00 PM »

Which two wires or all three?

imamafackinhokie · « **Reply #4 on:** October 27, 2004, 10:15:00 PM »

The a19 wire and the power or the a19 and the ground or all three?

terrorvis · « **Reply #5 on:** October 28, 2004, 02:49:00 AM »

Whao! Only two. Use A19 and Ground. DO NOT ATTACH A WIRE DIRECTLY FROM 5V TO GROUND. It could take out your psu, and more.

Author Topic: Tsop Semi-messup (Read 33 times)