xboxscene.org forums

OG Xbox Forums => Modchip Forums => TSOP flashing => Topic started by: imamafackinhokie on October 19, 2004, 03:58:00 PM

Title: Tsop Semi-messup
Post by: imamafackinhokie on October 19, 2004, 03:58:00 PM

Ok I installed a switch on a 1.0 and booted up and did a mechassualt exploit then flashed the tsop with a 512 kb switch.  The thing is the switch was in the off position and I thought i had it on.  I can boot using the x2 bios i put on to a dashboard, but i cant boot at all with the m$ bios.  What i am asking is how to i go about reflashing the m$ bios, should it be 1 mb when i reflash it with the switch off in evox or should it be something else?

lordvader help me out here

Title: Tsop Semi-messup
Post by: imamafackinhokie on October 19, 2004, 05:35:00 PM

Any advice?

This post has been edited by imamafackinhokie on Oct 20 2004, 12:37 AM

Title: Tsop Semi-messup
Post by: acemilo on October 19, 2004, 06:10:00 PM

You have 2 choices.  You can boot up the xbox, then when you go to flash it just switch it over to the other bank and reflash it with a 512, or turn on the xbox, disconnect the switch (alternatively you can cut the wires first and twist the 2 wires together to boot then untwist) and flash the bios with a 1mb with half x2 and half retail.

Title: Tsop Semi-messup
Post by: imamafackinhokie on October 26, 2004, 01:43:00 PM

Which two wires or all three?

Title: Tsop Semi-messup
Post by: imamafackinhokie on October 27, 2004, 10:15:00 PM

The a19 wire and the power or the a19 and the ground or all three?

Title: Tsop Semi-messup
Post by: terrorvis on October 28, 2004, 02:49:00 AM

Whao!  Only two.  Use A19 and Ground.  DO NOT ATTACH A WIRE DIRECTLY FROM 5V TO GROUND.  It could take out your psu, and more.