Topic: Alternate Solder Points On 1.5 (Read 29 times)

nitrate · « **on:** January 21, 2004, 11:02:00 PM »

Is there any alternate solder points for the 1.2-1.5 xboxes?
<

terrorvis · « **Reply #1 on:** January 22, 2004, 11:23:00 PM »

Follow the line on the PCB and find another point. Shouldn't be too difficult. Check with a multimeter.
You will need some wire though. Cut up an old IDE cable.

This post has been edited by terrorvis: Jan 23 2004, 07:23 AM <

terrorvis · « **Reply #2 on:** January 22, 2004, 11:42:00 PM »

Found this...
LINK <

rzatt · « **Reply #3 on:** January 23, 2004, 01:50:00 AM »

terrorvis,
Thanks for the link, but do you know if this is this the same for 1.5 boxes

Thie pic says 1.0-1-1

Also,
I thought there was only an alternate/optional solder point on the top of the board. This seems to have one on the top and bottom. Any thoughts on that ?

-RZ

<

ally-mcbeal · « **Reply #4 on:** January 23, 2004, 03:53:00 AM »

I thought a 1.4/1.5 just required 2 connections on the top?? <

NeoKast · « **Reply #5 on:** January 23, 2004, 08:14:00 AM »

Two points on top is all you need. Yep. <

rzatt · « **Reply #6 on:** January 23, 2004, 09:54:00 AM »

Anybody have a good pic/link of the 2 new points required on the top of 1.4/1.5 ? Some people even say there are 3

I did the old school top and bottom points on the 1.5 I am currently doing. No wonder why I cant flash it yet..doh

In the tutorials section of xbox-scene, it seems to only have the older ones (top & bottom) and the Sharp extra wire point .

Thanks

-RZ

This post has been edited by rzatt: Jan 23 2004, 06:47 PM <

Author Topic: Alternate Solder Points On 1.5 (Read 29 times)