Topic: Just Installed Chip...but Only Fragging (Read 158 times)

Majn00n · « **on:** April 11, 2005, 07:10:00 AM »

Well i just tried installing my xenium using the quicksolder method. Not sure what the problem is

. All my xbox does is turn on and off 2 times then turns on a 3rd time and flashes green and red. I have no idea what is wrong. But the bottom d0 points doesn't seem to be there anymore because the wire i soldered onto it came off somehow, and the point near it is also gone. Also, i think a track also came off. I don't know how it all came off. I did it so well. Any ideas, suggestions, help, please? Ill be very grateful for any help given. Thanks

KeyMastur · « **Reply #1 on:** April 11, 2005, 08:23:00 AM »

well if you burnt a trace then you're screwed - you'll have to repair that. otherwise i'd say just check your solder points again and again.

spyman · « **Reply #2 on:** April 11, 2005, 08:58:00 AM »

you will have to repair the trace

This post has been edited by spyman: Apr 11 2005, 03:58 PM

Majn00n · « **Reply #3 on:** April 11, 2005, 10:55:00 PM »

How would i go about fixing the screwed trace? Any help will be greatly appreciated

acemilo · « **Reply #4 on:** April 12, 2005, 12:17:00 PM »

There is a tutorial on the main page showing how to do it.

Author Topic: Just Installed Chip...but Only Fragging (Read 158 times)