Thanks all. But I expected problems and I didn't seal anything up. The hdd and dvd are almost flopping in the wind.
But the 5v is atached nicely. I redid the LCP build so the 3.3 was not attached and I still am able to boot to ms dash when chip is off. The light is red at that point. HDD and Lan lights still active though. With a quick push on the power the mod shows that it is enabled buy going to blue. Hdd and lan still active. Unable to connect to the chip via http and also tried putting a bios.bin (x3 v1.6) and that did not work.
1. What should the dip switches be at for the cromwell bios to show?
2. I noticed before I even installed the chip that the white X on the chip had little brown circular (almost scorchmarks) on the bottom left of the X. The side where the red wire 2 prong goes to the font of the box. Is that common like a stamp of approval or a messed up chip.
3. Where can I find a pic of bios banks and dip switches.
You guys and girls are the best. I thank all your hard work and support.