Topic: Xbox Acting Wierd With Aladdin 32 Chip (Read 113 times)

ps2gamer02 · « **on:** August 08, 2004, 09:16:00 PM »

my xbox is acting wierd like sometimes it wont boot the original bios unless i unplung the AV cables an then satrt it up an then i installed evox dashoard an when i tye to play a game with it it just freezes an i think it might be a problem with my D0 point or my lpc points can someone help me out?

ps2gamer02 · « **Reply #1 on:** August 10, 2004, 02:12:00 AM »

help plz

Koolkat · « **Reply #2 on:** August 10, 2004, 09:10:00 PM »

Are you using the alternative D0 point?
Are you using the BT, LT, or D0 points on the modchip?
What version is your xbox? If it is a v1.5, it requires extra installation points.
Which BIOS does your mod have on it?

This post has been edited by Koolkat on Aug 11 2004, 04:12 AM

ps2gamer02 · « **Reply #3 on:** August 11, 2004, 05:27:00 PM »

i didnt use the alternate D0 point i used the other side of the orginal D0 point which is next to the corner of a lil yellow box an yes i solder all the other point an my xbox is a 1.0 (very old) an i dunno what bios when i boot to the bios its has a small sign in ther top left hand corner that says evox thanks for the help

Snoopy007 · « **Reply #4 on:** August 11, 2004, 07:16:00 PM »

maybe bad contact on the soldering?

Koolkat · « **Reply #5 on:** August 11, 2004, 09:50:00 PM »

(IMG:http://www.aladdinlive.com/d0_4_.jpg)

I have a v1.0, too. You might want to use wires since the LPC holes have solder in them already. It sounds like you are using the alternate D0 point because it is near a yellow box, check the pic to verify. Try using this point, connect the D0 to a Ground. Is the evox symbol a pink triangle in the top left corner?. If it is, you have the EvoX M8 BIOS.

Author Topic: Xbox Acting Wierd With Aladdin 32 Chip (Read 113 times)