Topic: Few Questions... (Read 690 times)

oddmoen · « **on:** June 11, 2002, 03:52:00 PM »

hi i have two questions
1. wich mod chip i need 5V ,12V i know that it have to be 256kb or higher!
2. i have downloadet a file named "working xtender 1,1.bin" is this the right file?? (256kb)
if i have the wrong file please email me the right file [email protected]

ciao

DeMOnS · « **Reply #1 on:** June 11, 2002, 04:27:00 PM »

The chips 'working' voltage would have to be 5V, as that is the line you pick up from the X-Box mobo.

Dont know if anyone has found a 12V pickup yet, I guess there must be one somewhere. I know for sure there is a 3.3V line on the board (Very near the 5V one that xtender uses).

Good luck.

oddmoen · « **Reply #2 on:** June 12, 2002, 04:58:00 AM »

right image??

DeMOnS · « **Reply #3 on:** June 12, 2002, 04:42:00 PM »

Filename looks right but there are alot of fake images kicking around (Why people do it is beyond me).

Open the image file you have in a hex editor and go to offset $CFA (Hex) and you should see the m$ copyright message the bytes following the message are :-

2E 82 04 D4 2E

This can be confirmed by looking at the Hex dump 'snippet' that remains on 'bunnie's' Site (after m$ asked him to remove the full image).

Not much to go on but its better than nothing.

Hope it helps.

Author Topic: Few Questions... (Read 690 times)