Print

[Heimdall]

QUOTE(MrMajst3r @ Jun 28 2012, 08:18 PM)

When I try to flash, I get "flash error" in Gentoox and "flash not writeable" in Evox.

What about the rest of the error message? You know, the important bit, where it gives you some numbers about the flash type, for debugging.......

As to your question, you put a working BIOS on the 29 wire chip, solder it to the Xbox, boot, remove the chip (or at least cut a couple of the wires), then flash.

[Heimdall]

Good to hear you are using HeXEn

You aren't flashing the TSOP, you are flashing the chip.

Which error message do you get when using Evox to flash? I suspect that it's "Manufacturer's ID 09 Device ID 00", but it would be useful if you could confirm.

[MrMajst3r]

I've followed by this tutorial, and SUCCESSFULY flashed TSOP with HEXEN.

Thanks, you are really master of Xbox! I suggest you, to write a guidebook about Xbox I will order one, with your autograph