Alright i got a v1.6 console with a duox2 chip installed and decided i wanted to put a xenium ice chip in it. I added the two additional pins onto the pin headed that the xenium require but for some reason i almost always get a constant frag. Sometimes it will work and other times it will not. I plugged in the additional wire loom, the one with the d0 and the optional ground, and figured out that if i solder the ground wire to the d0 spot on the chip it works just fine. My question is will this mess anything up or is the chip needing additional grounding? I tried to solder the ground onto a screw hole but it continued to frag, so i just resoldered it back onto the d0 point. Any help appreciated. TIA!