Topic: Just Installed, Booting To Original Xbox Dash (Read 91 times)

..::SEBBY::.. · « **on:** December 12, 2004, 11:42:00 PM »

power on witht the eject button to boot to the OS

soulseller · « **Reply #1 on:** December 13, 2004, 06:05:00 AM »

it does not matter if i power up with the power button or the eject button, both bring me to the MS Dash. The LED on the Xenium chip is flashes bright red when I first turn it on and then goes steadies at a steady but softer red.

X-ECUTIONER · « **Reply #2 on:** December 13, 2004, 07:04:00 AM »

soulseller · « **Reply #3 on:** December 13, 2004, 10:06:00 AM »

Originally I had the LFrame soldered from an LFrame point on the board to the DO pad atop the chip, no ground. I Just took that wire off and used the blue and black wire with white connector that came with the chip, soldered blue to the LFrame point and the black to one of the metal screw holes for ground.

Now the eject button LED is flashing green/red, nothing on the screen and a bright red LED on the chip itself.

soulseller · « **Reply #4 on:** December 13, 2004, 02:43:00 PM »

my two biggest questions to other installers are:

should i use the blue and black wire with white connector that came with the chip, or just solder my own D0 connector wire.

Second do I need a ground wire? If yes and if answer to question one was not to use provided connector, where should I solder the ground wire on the chip?

..::SEBBY::.. · « **Reply #5 on:** December 13, 2004, 03:00:00 PM »

Did you do the additional steps to install on a 1.6?

soulseller · « **Reply #6 on:** December 14, 2004, 07:58:00 AM »

so last night i took the chip out and it is still fragging!?!?

joker55 · « **Reply #7 on:** December 14, 2004, 02:07:00 PM »

i just got my ice(mod) & i had the same prob..with the red light...& i'm runing on v1.5..my prob was (since i didnt soder) it was loose so i put a pice of fome on one side a cocked the mod chip to get better connt. worked great. but now since i am a newbee i just figured out how to flash my bios..but dont know how to get the dashbord working or even the bios... can anyone help me?

looking for evox dashbord.. found many..none work..think i need iso?

joker55 · « **Reply #8 on:** December 14, 2004, 05:50:00 PM »

someone help me pls.

Artifex · « **Reply #9 on:** December 15, 2004, 07:13:00 AM »

soulseller: Looks like your soldering is no good. Check it all over with a multimeter.

joker55: Firstly, it's not nice to hijack other people's threads with different problems. Second, your question doesn't belong in this forum.... as it's not a problem with the chip. Try asking in the appropriate forums.

--Artifex

joker55 · « **Reply #10 on:** December 15, 2004, 12:28:00 PM »

Author Topic: Just Installed, Booting To Original Xbox Dash (Read 91 times)