Topic: Need Help, Xbox Frags (Read 244 times)

jameswalter · « **on:** October 20, 2005, 05:22:00 PM »

Sounds like it isn't correctly installed. Does it give an error number?

greenday54261 · « **Reply #1 on:** October 20, 2005, 05:35:00 PM »

You need to check your modchip installation VERY carefully. The "christmas lights syndrome" (llamma.com) is usually caused by either a bad modchip or broken traces on the mobo.

ace_012 · « **Reply #2 on:** October 20, 2005, 05:45:00 PM »

ace_012 · « **Reply #3 on:** October 20, 2005, 06:05:00 PM »

Well the edit button disapered so srry for double post but...my luck just got worse, my damned xbox WONT TURN ON!! even without the chip in or anything, I dont understand I didn't do anything!!!!!!!! It just wont turn on now!!!

CGras90 · « **Reply #4 on:** October 20, 2005, 06:23:00 PM »

did u put a v1.6 xbox into an older case, if so your transitor is blown

Chancer · « **Reply #5 on:** October 21, 2005, 04:45:00 AM »

QUOTE

But it still turns on, turns off, turns on, turns off, turns on then FRAG's

Problem will not be a bad chip but down to the install of the chip. these are notorious for poor LPC alignment and connection
have a look SpiderChip Guide
Moving to Spider forums

ace_012 · « **Reply #6 on:** October 28, 2005, 04:50:00 AM »

Alrighty, now I just need to find out what a transistor is and where it is on the motherboard.....

Chancer · « **Reply #7 on:** October 28, 2005, 06:41:00 AM »

Click the no powewr 1.6 link in my signature

ace_012 · « **Reply #8 on:** October 28, 2005, 02:24:00 PM »

Thanks guys, I hope this works.

PS- When it says 1.6 it means 1.6 & 1.6b right?

Author Topic: Need Help, Xbox Frags (Read 244 times)