I have one new spider gx and i have installed it. Flashed it. And now, I use it. That work very fine.
If you check on the manuel on the www.spidergx.com you can see that your "mystery" pin is only D0.
On the pcb with the wires you have 2 wire D0.
It's easy to understand. All the other wires (5) are used for xbox 1.6 only.
And the "mystery" wire, is used for the other version wich don't use the other wires.
So if you have one 1.6 xbox you must cut the mystery pin.
If you play with this wire, and you try to flash. You say it's doesn't work.
Of course. If you place this wire on the bad place, the spider will be disabled and after the flash can't work, and in more you can damage it if you don't follow the installation manual of the website.
After you flash the bank1 and no work.
Here too. After flash the bank1 and >END appear, that mean you have successful flashed your spider. If you want use the bank1 you have 2 ways:
1- set the switch to bank1. (OFF-OFF-OFF-ON)
on the switch 0 mean OFF (need to put the switch on the bottom (connector side).
2- set the switch to auto (OFF-ON-ON-ON) and then set in the spider OS bank1 in the autoboot menu.
For me all work very fine. Even the 512KB bios of xecuter work fine when flashed on bank3.
I have a xbox 1.6.
If you can see the spider os start, no need to tuch again your wire or installation. That want say all is very well installed.
If after flash that frag 3x, that mean OR your bios is not compatible with the version of your xbox OR the switch are not on the good position to use the bank you choose to place your bios.
QUOTE(Kallidoan @ Oct 2 2005, 07:06 AM)