xboxscene.org forums

Author Topic: Chip Working In One Box But Not The Other?  (Read 73 times)

modderguy791

  • Archived User
  • Full Member
  • *
  • Posts: 158
Chip Working In One Box But Not The Other?
« on: February 23, 2008, 02:12:00 AM »

I had 2 DuoX2 GS chips i was installing in 2 xboxes, both were installed the same way and if i know the versions correctly theres not much installation difference.

First i tested both chips in a v1.4 box, both chips worked flawlessly.

Then i tryed them both in a v1.2/1.3 box and neither of them work? the xbox boots normally (with the flubber screen and everything) and the light on the chip does not come on.

I am using the d0 ground on the bottem of both boards.

any ideas?
Logged

modderguy791

  • Archived User
  • Full Member
  • *
  • Posts: 158
Chip Working In One Box But Not The Other?
« Reply #1 on: February 24, 2008, 08:33:00 PM »

Anyone have a solution for this?
Logged

Alex548

  • Recovered User
  • Hero Member
  • *
  • Posts: 1717
Chip Working In One Box But Not The Other?
« Reply #2 on: February 24, 2008, 09:21:00 PM »

Check the soldering on the LPC. Sounds like that might be your problem especially if you're not getting power to the chip.

Also make sure you have the BT wire connected as well during your testing.


This post has been edited by Alex548: Feb 25 2008, 05:22 AM
Logged

litspliff

  • Archived User
  • Hero Member
  • *
  • Posts: 569
Chip Working In One Box But Not The Other?
« Reply #3 on: March 03, 2008, 10:21:00 PM »

yes, it sounds like a botched (LPC) install on the 1.2/3.

if you don't want to hook up the BT to the eject button, bridge it to the X on the LPC diagram below.

 

OxO**O

OOOO*O

Logged