I checked my D0 for continuty from the d0 point on the chip to the d0 point on the back of the MB and it is all good. But when I go to boot it just frags which could mean loading my onboard bios since it is screwed. Do I have to connect the 5V and ground? If so to where and is there a way to install the chip with wires instead of the pin header? I am soldering the pin header in instead of solderless adaptor because I heard a lot of problems with the adaptor but now I have those same problems with the solder.
My box did bot to cromwell the first time I turned it on then I hit the eject button after flashing my tsop (I connected tha a15 point) and now the chip doesn't load at all is it still in off mode how do I turn it back on if it is? Just questions any one have any ideas?