xboxscene.org forums

Author Topic: Frag After Working  (Read 61 times)

animex2

  • Archived User
  • Sr. Member
  • *
  • Posts: 326
Frag After Working
« on: July 10, 2004, 08:20:00 AM »
Hello, I just installed a X-B.I.T chip, Got the bios on it and everything, (did a wire install) and i installed evox fine, it was working, i went to put the xbox back togeather, all it does is frag, i TRIPLE checked every connection... Frag... It boots up fine on stealth mode, but it will not boot up regualrlly.... Thanks...
Logged

animex2

  • Archived User
  • Sr. Member
  • *
  • Posts: 326
Frag After Working
« Reply #1 on: July 10, 2004, 08:21:00 AM »
never mind... I dicided to insulate it in Electric Tape... But that caused it to not work for whatever reason, works fine....

how am i supposed to mount this chip if there are points that will conduct electicity on both sides?
Logged