xboxscene.org forums

Author Topic: Need Help After Chip Flash  (Read 45 times)

DevHeadMX

  • Archived User
  • Newbie
  • *
  • Posts: 5
Need Help After Chip Flash
« on: February 06, 2004, 02:41:00 AM »
Any help would be greatly appriciated
Logged

cisco7200

  • Archived User
  • Full Member
  • *
  • Posts: 111
Need Help After Chip Flash
« Reply #1 on: February 06, 2004, 05:03:00 AM »
Try a different bios like m7, 4980, or 4981.  Make sure you have the correct bios bank selected.
Logged

thebigyin5555

  • Archived User
  • Newbie
  • *
  • Posts: 38
Need Help After Chip Flash
« Reply #2 on: February 06, 2004, 05:35:00 AM »
It sound like you have the wrong BIOS bank selected. Check the dip switch settings.
Logged

DevHeadMX

  • Archived User
  • Newbie
  • *
  • Posts: 5
Need Help After Chip Flash
« Reply #3 on: February 06, 2004, 06:02:00 PM »
jester.gif
Logged

incyte

  • Archived User
  • Newbie
  • *
  • Posts: 34
Need Help After Chip Flash
« Reply #4 on: February 06, 2004, 07:25:00 PM »
biggrin.gif  

anywho...i recommed downloading xbtool... change the color of the led around the eject button and the xbox logo to tell if your bios is loading the modchip or the m$ one. I changed mine to all red.

xbtool is on xbox-scene here...

THen you should download Slayers evox auto installer easiest thing to install the dash

if you need to know where pm me

hope this helps
Logged

DevHeadMX

  • Archived User
  • Newbie
  • *
  • Posts: 5
Need Help After Chip Flash
« Reply #5 on: February 06, 2004, 07:32:00 PM »
Helps a ton, thanx!  Does it make any difference that the LED is on when connected to PC but not when Xbox is powered up?  Also, if I used the wire install method do I still need to screw the chip to the board?

I set the switchees the way you suggested.  The LED light comes on but whn I boot it frags?  Red/Green etc etc....any suggestions?
Logged