Topic: X.b.i.t Solder Free On V1.0 Xbox Problems? (Read 65 times)

Curtisbeef · « **on:** October 27, 2003, 09:01:00 AM »

Sorry if this is a topic that has been covered i have searched but i cant seem to find and documentation

Has anyone installed a X.B.I.T on a version 1.0 xbox that has the LPC holes filled with solder

does it sit tightly?

Any problems with alignment?

pieces · « **Reply #1 on:** October 27, 2003, 02:34:00 PM »

I have done pogo install on both 1.0 and 1.1 and it was easier on the 1.0 I believe becasue of the filled lpc holes had better contact and more surface area. The pogo's that sit on the lpc are round and didnt seem to lock in on either version but I think that the no soldier holes may help keep the chip aligned if it were jared. It did sit tightly but im not shaking the hell out of them or plan on dropping either one.

Curtisbeef · « **Reply #2 on:** October 27, 2003, 02:43:00 PM »

Thanks for the responce

I was worried it wouldnt work right

gadgetaddict · « **Reply #3 on:** October 28, 2003, 05:59:00 AM »

mine worked fine. if you want, gently "exercise" the pins by holding their tops, and gently pressing each pin a couple of times to work out any possible kinks with their springs. be especially careful with D0; i had to resolder mine as it came loose.

Author Topic: X.b.i.t Solder Free On V1.0 Xbox Problems? (Read 65 times)