xboxscene.org forums

Pages: 1 [2]

Author Topic: Xbit Feedback  (Read 177 times)

hirakubo

  • Archived User
  • Newbie
  • *
  • Posts: 8
Xbit Feedback
« Reply #15 on: October 16, 2003, 09:23:00 AM »
I used Popopins for my XBOX. I only had 1 problem: i had to scrape D0 point, but after doing that, installation was *VERY EASY*.

Logged

FunkmaztafoX

  • Archived User
  • Sr. Member
  • *
  • Posts: 299
Xbit Feedback
« Reply #16 on: October 16, 2003, 01:53:00 PM »
ok so what is everyone talking about scarping the D0 point?
Logged

jaYuxYaXbox

  • Archived User
  • Newbie
  • *
  • Posts: 19
Xbit Feedback
« Reply #17 on: October 17, 2003, 09:28:00 AM »
I finally got the chip and did the wire install- everything went perfectly. I flashed it using XP w/out a hitch... couple of bioses on there and right now just working on installing everything. so far so great.
Logged

SNICK!

  • Archived User
  • Full Member
  • *
  • Posts: 214
Xbit Feedback
« Reply #18 on: October 17, 2003, 10:15:00 AM »
hi

i have already done a cheapmod in my bros xbox and have just installed a akira into mine and dont want to replace that with the xbit (the akira rules!).

now i want to replace the cheapmod in my bros xbox with a bit and saw the pin header install used a female header for the xbit. is there anyway to make it so that i can fit the bit on a male header?

cheerz
Logged

Dv

  • Archived User
  • Newbie
  • *
  • Posts: 1
Xbit Feedback
« Reply #19 on: October 18, 2003, 07:24:00 PM »
sad.gif
Logged
Pages: 1 [2]
« previous next »