Print

[dbdlowrider]

ok i got my lcd screen 2 days ago and i mounted it in a old case i had just 2 get an idea. but it didnt work 2 good and the xecuter site just tells u 2 plug it up not how 2 mount it. any tut. <

[Tobb555]

Get the X3CP If you dont want to hack your case up. <

[Silentscream__]

QUOTE(Tobb555 @ Apr 6 2005, 04:07 PM)

Get the X3CP If you dont want to hack your case up.

He has a clear orange case - I dont think that that would really go with black, crystal, or green.

You will have to bust out the dremel and cut a hole for the LCD to sit in, then you could probably hold it in place with some hot gluie or something. <

[haloloser]

you're going to have to cut your hole just a little bit small and finish the rest with sand paper to inusre that you dont overcut. <

[custard]

if you cut it tight enough it holds well with a little hot glue,invest in a dremel(or dremel type)fro the cutting as it saves a lot of work <

[dbdlowrider]

i got a dermal and i know i have 2 cut a hole but i dont think hot glue would look good on a clear case



 my case is yellow but i am sellin it and getin a clear 1 <

[xbox_maister]

QUOTE(dbdlowrider @ Apr 7 2005, 05:53 PM)

i got a dermal and i know i have 2 cut a hole but i dont think hot glue would look good on a clear case
 my case is yellow but i am sellin it and getin a clear 1

well, if your selling the yellow one and goung for an crystal LE case the go with an x3cp, but if you do hold it with hotglue then just apply as little as possible and it should turn out ok..


xM <

[Hozy]

You could always get the x3 cp, use some 2000 grade and try and get some 3000grade sandpaper, and buff/polish the grain out of it and tint it, It CAN be done but would take some effot but would be worth it in the end, then tint it

Just my opinion

Kindest Regards
HoZY

This post has been edited by Hozy: Apr 7 2005, 08:03 PM <

[dbdlowrider]

dont the x3cp have the lcd in it cuz i got a lcd and pro switchs <

[custard]

i used hot glue on 2 i did.only applied a little to the bottom and most to the top as it has a lip so you cant really see it.though when i installed it i left a 3-4mm piece of plastic on the top whereas most people seem to cut straight down and not leave any plastic at the top <

[dbdlowrider]

i just got an idea u know how it has screw holes in it. they could make a bracket so it mounts 2 the hdd. i think i might make 1 when i get home. If it work i will get some pics. <

[dish_newb]

i got a x-s member customizing me a front panel




hes cutting me a hole for the xlcd on the left side
pm me if you want his info.. <

[dbdlowrider]

QUOTE(dish_newb @ Apr 8 2005, 12:07 PM)

i got a x-s member customizing me a front panel




hes cutting me a hole for the xlcd on the left side
pm me if you want his info..

 i would but i like doin my own work i think it is a waste of time it just take a lil bit of work not hard and plus i like doin it 2. 4 ports on 1 side looks nice i had 1 like that once upon a time. lol i have had like 6 or 7 diff case. i still do <