OG Xbox Forums > TSOP flashing
Failed Tsop Flash
(1/1)
dredzs:
I was updating a friends softmodded xbox. It's a v1.0 xbox so it has the 1mb bios. So I made the appropriate size bios file, loaded it with the 007 exploit, erased it and flashed it. When I went to go reboot it, it doesn't boot at all. The green comes on for a second and turns off.
So, my thought was that when whoever modded it, didn't solder one of the jumper points, making it so that I only have access to one half of the bios. Any thoughts or tips?
dredzs:
I checked the points and all are good. How do I reflash it? I know you can just install a chip and forget about the tsop, but I would like to try to reflash the tsop (I hate just ignoring a problem).
in8:
QUOTE(dredzs @ Feb 7 2007, 11:51 AM)
I was updating a friends softmodded xbox. It's a v1.0 xbox so it has the 1mb bios. So I made the appropriate size bios file, loaded it with the 007 exploit, erased it and flashed it. When I went to go reboot it, it doesn't boot at all. The green comes on for a second and turns off.
So, my thought was that when whoever modded it, didn't solder one of the jumper points, making it so that I only have access to one half of the bios. Any thoughts or tips?
QUOTE(dredzs @ Feb 7 2007, 03:19 PM)
I checked the points and all are good. How do I reflash it? I know you can just install a chip and forget about the tsop, but I would like to try to reflash the tsop (I hate just ignoring a problem).
A softmod does not require any jumper points to be soldered. Also the tsop wouldn't be writable without those points (both of them) enabled. To try to reflash the tsop, have a look at this thread http://forums.xbox-scene.com/index.php?showtopic=131986 . Honestly, it might just be best to get a cheap mod chip and say good riddance to the tsop.
Thanks,
~in8
This post has been edited by in8: Feb 8 2007, 05:25 AM
StrictPuppet:
What bios did you flash to the tsop?
dredzs:
I flashed X2. I already gave up and just chipped it.
Navigation
[0] Message Index
Go to full version