actually this will cause the opposite...
You have to use less thermal compound I guess and you have to tighten the screws up so that the heatsink gets good contact with the chip die...
Clean it from all AS5 until you get a mirrorfinish then use an amount of AS5 equal to the size of a ricegrain and evenly spread it over the whole die using a creditcard make sure you apply it to both chip dies of the GPU.
The finer the layer of the thermal compound the better it conducts the heat then make sure the heatsink is screwed tightly to the board. Then turn it on. If it still gets the 2 RLOD get the secondary error code as it might also be the RAM or the CPU...
To the other dude E74 is aproblem with the connection of the GPU to the scaler-chip, this tutorial clearly eyplains what to do make sure you read all the posts up to page 2 at least as there are some useful hints.
http://forums.xbox-s...howtopic=646900Good luck
Thanks for the help. I am gonna have to wait to do this till school lets out and I go home and have my tools. Hopefully it works.