Print

[Dicko316]

Trim the trace so you dont pull it off anymore, then run two pieces of wire from C5R11 (the pad that is joined to the trace of FT4R2, closest to center of CPU, C5R11 is under the Xclamp) then solder one end of the wire to the resistor topside of the motherboard that is labled R4D4 (Also the side closest to the CPU, located near the edge of the heatsink) Then use the spare end of the wire for your new CPU rest point (eg solder to the glitch chip)

[kanxp128]

QUOTE(kanxp128 @ Nov 10 2012, 10:16 AM)

It is a slim. Hope it can fixed, by the way which xsvf should  I use for slim 14719 with Rgh1 chip and super nanda flasher procedure to xsvf the chip ,tks a lot

Thanks for your help, it's work.