I just got AfterTheInsanity's usb flasher to work correctly with my computer/xbox and made 4 dumps, three of which were identical. I ran the dump through degraded and it was exploitable so i extracted the keyvault and the config from the dump and merged them with the xbr image, which i then flashed to the nand, which went fine.
I connected the psu and the vga cable and it booted with an error 79. so I tried to dump the flashed image and compare it with the original one but found out that i couldnt access the nand (error reading (or programming) [address]).
I checked my joints and noticed that one of the JTAG wires was undone so i put it back together. I booted again and the top left, bottom left and right were red and there wasnt any video output. I soldered one of the points back to db1f1 (i had it at the alternate) but still have the same result.
Is there anything else I can do?
Edit: I just opened my original dumps in 360flashtool and the cpu key field is all 0's, is that bad? Also extracting the config with nandpro results in a 33kb file while extracting it with 360 flash dump tool results in a 32kb file. which one should I use? Originally I used the one extracted with nandpro