Topic: Xbox Hdm Problem (Read 205 times)

angelicsentinal · « **on:** February 21, 2010, 09:42:00 AM »

Xbox HDM boots fine but when I try to enter a command it won't detect the CD. Could this be because I have a SATA CD/DVD drive? I hope not because I only have one IDE header on this board and I'm not sure if Xbox HDM will detect the hard drive if I have a slave drive. Although it should because it's not a hard drive out of an Xbox, so it's not locked. I just need HDM to install Ndure/UnleashX and to lock the new hard drive.

Heimdall · « **Reply #1 on:** February 21, 2010, 09:46:00 AM »

Yes, that's the problem. Try xboxhdm 2.1 instead.

angelicsentinal · « **Reply #2 on:** February 21, 2010, 09:52:00 AM »

I never knew there was anything beyond 1.9, but I guess there is. I'll give it a try.

angelicsentinal · « **Reply #3 on:** February 21, 2010, 12:27:00 PM »

After a while of testing I finally got it working off a USB flash drive. Thanks a lot. Sucks though both by 40GB hard drives don't support ATA security.

worldwhore3 · « **Reply #4 on:** February 23, 2010, 11:27:00 PM »

sell 'em on ebay. with the money you make on ebay, buy a newer drive that more than likely will support it.

angelicsentinal · « **Reply #5 on:** February 24, 2010, 01:13:00 AM »

I doubt anyone would buy them man, 40GB IDEs are pretty much junk these days.

Author Topic: Xbox Hdm Problem (Read 205 times)