xboxscene.org forums
OG Xbox Forums => Modchip Forums => TSOP flashing => Topic started by: a9h3x on October 01, 2003, 12:41:00 AM
-
Heres the deal... I got this xbox and they removed the top solder pads for the top tsop bridge points in the picture.. is there any other alt points for these? as i would like to flash the tsop on this mobo
(IMG:http://www.lr2g.com/storage/a9h3x/points1.0top.jpg)
This post has been edited by a9h3x: Oct 1 2003, 07:42 AM
-
YES
get a piece of thin multi strand wire
using just one strand of the very very thin wire for each hole, poke it through the holes where the tracks from these pads run to...
which should give you 2 larger solder pads underneath about 4mm apart in a diagonal direction - like the alt D0 point underneath
YOU MUST CHECK THIS YOURSELF so don't say it don't work or it screwed ya mobo up coz I have done it twice on ver 1.0 and also on a ver1.2 and 1.3 mobo
link these 2 pads with a piece of kynar wire and flash away
NOTE - they both go to 2 PADS aprox 2mm in diameter and 4mm diagonally apart - if ya take ya time you can work it out easily - just take ya time and double check
the thin wires will show up clearly coz these holes will allow the tiny thin wire to pass all the way through the mobo
best of luck
-
I can't remember who, but someone pointed out some alternative points for these in an earlier thread. Here's the page:
Top Tsop points:
This post has been edited by wiseblood: Oct 3 2003, 07:10 AM