xboxscene.org forums

OG Xbox Forums => Modchip Forums => Team Xodus Chips (Xenium) => Topic started by: Majn00n on April 11, 2005, 07:10:00 AM

Title: Just Installed Chip...but Only Fragging
Post by: Majn00n on April 11, 2005, 07:10:00 AM

Well i just tried installing my xenium using the quicksolder method. Not sure what the problem is :(. All my xbox does is turn on and off 2 times then turns on a 3rd time and flashes green and red. I have no idea what is wrong. But the bottom d0 points doesn't seem to be there anymore because the wire i soldered onto it came off somehow, and the point near it is also gone. Also, i think a track also came off. I don't know how it all came off. I did it so well. Any ideas, suggestions, help, please? Ill be very grateful for any help given. Thanks

Title: Just Installed Chip...but Only Fragging
Post by: KeyMastur on April 11, 2005, 08:23:00 AM

well if you burnt a trace then you're screwed - you'll have to repair that. otherwise i'd say just check your solder points again and again.

Title: Just Installed Chip...but Only Fragging
Post by: spyman on April 11, 2005, 08:58:00 AM

you will have to repair the trace

This post has been edited by spyman: Apr 11 2005, 03:58 PM

Title: Just Installed Chip...but Only Fragging
Post by: Majn00n on April 11, 2005, 10:55:00 PM

How would i go about fixing the screwed trace? Any help will be greatly appreciated

Title: Just Installed Chip...but Only Fragging
Post by: acemilo on April 12, 2005, 12:17:00 PM

There is a tutorial on the main page showing how to do it.