xboxscene.org forums
OG Xbox Forums => Hardware Forums => General Hardware/Technical Chat => Topic started by: Pooky on January 20, 2004, 02:07:00 PM
-
I was preparing a xbox for flashing the tsop. I soldered the jumpers and the wires for the switch (not yet connected)
But now when i boot the xbox i don't get any video or audio and the dvd-tray won't eject. The led is solid green.
When i push the eject button the led is blinking and the dvd is searching. After that the xbox reboots. The led is blinking and after a while it's solid again. But still no video or audio and the tray still won't open.
I realy checked the mobo for solder but couldn't find anything. Is there an other thing that can cause such a problem.
Hope anyone can help me out
ps: i haven't flashed the tsop yet
-
i found this realy strange thing.
When i remove the solder of the bottom flash enable jumpers the xbox boots normal. The solder on the top jumper is still there. But when i solder the bottom jumpers i have no audio, video or eject.
can somebody tell me what is going on here.