| QUOTE (Exzir @ Oct 8 2004, 09:35 PM) |
| Also for a non solder d0 connection if you have a spare ide 80 pin cable take one wire from them and use a needle to inlargen the hole. It is called reeming and then you will be able to place the coper wire into the hole snugly. I have in fact done this over and over again on 1.0 and 1.1 boards I have not needed to do this on any 1.2 boards so I don't know how much reemng you would need to do on them. I am very taken that there is not a mention in a tut about how perfect 80 pin ide cable wire is so perfect for this stuff. |
thx guys, I have a look into both.
jippie
yes, the spot on the bottom is bigger but, not impossible to fuck up. i know because i did. my first mistake was using a shitty soldering iron, but it was what i had. finally i got the wire on there and somehow, i forget now i moved something and it pulled the wire and it came off--along with the solder point. So i had effectively grounded my d0. for good. i was not happy with myself. i did finally fix this problem with a better iron, i scraped the traces on either side of the point where the solder USED to be, and got a drop of solder to stick to the exposed copper on both sides. but still, it was an embarrasing fuck up.and i had to rig the shit back together. all of this to say, don't say "impossible to fuck up"
also, does anyone know a place where i can get some small gauge wire that's not like a whole spool? i really just need a little so if i could get it by the foot that would be better
This post has been edited by jbedwell81 on Oct 29 2004, 06:11 AM
Check out Ebay. 32awg wire is best to use.