xboxscene.org forums

OG Xbox Forums => Modchip Forums => Matrix & Chameleon Modchips => Topic started by: AndreM on October 02, 2004, 07:59:00 AM

Title: Matrix Mod Not Booting
Post by: AndreM on October 02, 2004, 07:59:00 AM

I'm trying to get a Matrix modchip to work. It worked but when transported it was misaligned. The problem was the screw which did not fit in properly. I have exchanged the screw and the modchip can be installed firmly. I have aligned the chip properly and tested using mode 1. When i change to mode 3 the LED flashes green and turns to red. When is select mode 2 the led turns green stays then the XBOX powers off and restarts, it does this 3 times. Nothing to see on the screen.

I hope anyone can help me... the holes are being filled with solder to get better connection...

Regards,
André

Title: Matrix Mod Not Booting
Post by: Exzir on October 03, 2004, 11:46:00 AM

You might want to try loosening the screw.  When you over tighten it some of the pins will not make a good contact.  The green light is only when the d0 is aligned and not that the chip is correctly installed.