xboxscene.org forums

OG Xbox Forums => Modchip Forums => EB2K Chips (X-Chip) => Topic started by: trainerbill on October 09, 2004, 08:13:00 PM

Title: Do You Have To Keep Usb Connection Hooked Up
Post by: trainerbill on October 09, 2004, 08:13:00 PM

Is there a way to run the mod chip once you have everything you want installed without having the USB connection?  Everytime i disconnect the USB the box would load my BIOS.

Title: Do You Have To Keep Usb Connection Hooked Up
Post by: mt80 on October 09, 2004, 08:46:00 PM

Once you write the bios to your chip using the USB connection you can disconnect it.

Title: Do You Have To Keep Usb Connection Hooked Up
Post by: trainerbill on October 09, 2004, 08:51:00 PM

why doesn't it work when i disconnet the usb then, did i install the chip wrong

Title: Do You Have To Keep Usb Connection Hooked Up
Post by: trainerbill on October 09, 2004, 08:55:00 PM

When i sisconnect the USB from the mod chip the LED on the Chip shuts off.  Is this a power issue?  Was the chip installed wrong?

Title: Do You Have To Keep Usb Connection Hooked Up
Post by: Grilf on October 10, 2004, 02:18:00 AM

Yes, if the LED is off then the chip receives no power.

Title: Do You Have To Keep Usb Connection Hooked Up
Post by: cravavr3 on October 12, 2004, 08:11:00 AM

If you have solder install, verify pin #6 is soldered in LPC port ( that is 5V ), if you are using solderless install, verify you have a pogo pin on where pin #6 is.