xboxscene.org forums

OG Xbox Forums => Modchip Forums => All other Alternative Modchips and Cheapmods => Topic started by: oddmoen on June 11, 2002, 03:52:00 PM

Title: Few Questions...
Post by: oddmoen on June 11, 2002, 03:52:00 PM

hi i have two questions
1. wich mod chip i need 5V ,12V i know that it have to be 256kb or higher!
2. i have downloadet a file named "working xtender 1,1.bin" is this the right file??   (256kb)
if i have the wrong file please email me the right file [email protected]

ciao                    

Title: Few Questions...
Post by: DeMOnS on June 11, 2002, 04:27:00 PM

The chips 'working' voltage would have to be 5V, as that is the line you pick up from the X-Box mobo.

Dont know if anyone has found a 12V pickup yet, I guess there must be one somewhere. I know for sure there is a 3.3V line on the board (Very near the 5V one that xtender uses).

Good luck.


                   

Title: Few Questions...
Post by: oddmoen on June 12, 2002, 04:58:00 AM

right image??                    

Title: Few Questions...
Post by: DeMOnS on June 12, 2002, 04:42:00 PM

Filename looks right but there are alot of fake images kicking around (Why people do it is beyond me).

Open the image file you have in a hex editor and go to offset $CFA (Hex) and you should see the m$ copyright message the bytes following the message are :-

2E 82 04 D4 2E

This can be confirmed by looking at the Hex dump 'snippet' that remains on 'bunnie's' Site (after m$ asked him to remove the full image).

Not much to go on but its better than nothing.

Hope it helps.