xboxscene.org forums
OG Xbox Forums => Modchip Forums => TSOP flashing => Topic started by: acemilo on September 20, 2004, 04:50:00 PM
-
Did you try telnetting in?
-
nothing will load enabling me to telnet into it... i have to use mech eurasia for winbond tsop.. is it the game??? can i use 007 to load mecheurasia??
-
http://forums.xbox-s...showtopic=61901
check out steps 15-24 that might help.
-
Get the 007 with raincoat exploit, load it, then you can telnet it to flash.
-
its 0.7 and it says cannot connect to host
-
a bit more info:
what bios did you put on there i f it was a m7.bin renamed to bios.bin then it should of flashed but you won't see anything different at xbox boot screen like:
XECUTER 2 - it will still say MS if the Evox bios was used
It sounds like it flashed - if anything wasn't writable or it couldn't find the bios to flash the eject tray would open
-
winbond are 256kb a quarter of the 1mb bios used on ver 1.0 & 1.1's
I KNOW IT TAKES 28 to 30 seconds on the old eurasia - no text or writing coz I've done enough 1.2/3/4 winbonds and even ST/hynix's that could go through evox but the eurasia save on it's own is fully automated
30 seconds after screeen goes black the xbox switches off - power it up with on/off switch and if flubber just starts to appear then press eject on dvd to remove the 007 original
IT WILL SAY M i c r o s o f t UNDER XBOX SCREEN COZ I USE M7
you mean to tell us you haven't even tried booting a backup or slayer evox disc ?
well try one burnt on a decent bit of media - not all drives will read cdr's so try a cd-rw or a good brand of dvdr media
-
you won't get a new dashboard you get a new bios that can boot the other dahsboards and run unsigned code
you need to install one with slayer or evox disc