xboxscene.org forums

OG Xbox Forums => Modchip Forums => TSOP flashing => Topic started by: brimX on August 04, 2003, 06:51:00 PM

Title: Tsop Switch
Post by: brimX on August 04, 2003, 06:51:00 PM

before i try anything i would like to verify this. please, if someone says its rite, then reply with your opinion so i can get more than one "OKAY'S".

this is wat im going to do:


i want to split my tsop in half (two 512's) with a switch that has three prongs. the middle goes to a19 and the two sides go to gnd and vcc.

is that the rite setup? or should i do it another way?

also...

should i solder the wires to a19,gnd,vcc and also the jumpers for write access all at the same time? or should i put the switch, see if it works, then jumper the points for tsop flashing?

please... someone give me there opinion in detail.

thanks

Title: Tsop Switch
Post by: cribby08 on August 05, 2003, 07:42:00 AM

There are also numberous tutorials that will tell you how.

Title: Tsop Switch
Post by: PsiDOC on August 05, 2003, 02:01:00 PM

Regards,
Psi