| QUOTE (craigncheri @ Jul 8 2003, 03:42 PM) |
| I've done 3 1.1's with sharp tsop's now using raincoat and the 007 trick this is what I did. when both jumpers were closed machine refused to boot on the retail bios so I had to leave the top jumper open to get the machine to boot. (you may or may not need to do this) I soldered a jumperwire on the bottom of the board to provide the voltage needed for the sharp tsop. there are diagrams of this in the tutorials section booted 007 and performed hack as normal except right before pressing enter on the ./raincoat -p bios.bin command I had a friend hold a small flat bladed screwdriver across the write jumper points on the top side the board. (remember my machine wouldn't boot with these points shorted) |