xboxscene.org forums
OG Xbox Forums => Modchip Forums => Team Xodus Chips (Xenium) => Topic started by: pezzar on October 31, 2005, 03:10:00 PM
-
the gold wires should just seat inside the holes. the holes may be covered with lacquer so clean them up first with a fibre glass prep pen and some surgical spirit
-
So you are suggesting me to clear the holes open with some sort of pin? am i suppose to penetrate the pin until it goes thru the motherboard? Im a total noob to this, so thanks for your suggestions
-
Can i use a needle to clear lacquer from the covered holes on the motherboard?
I need so much help!
-
Use a fibreglass pen to gently scrub the via. With the right tools it shouldnt be hard.
A pin really isnt the right tool, not sure if it will work. A fibreglass pen is static free and there is less of a chance that you could screw things up.
-
i use a pin to break the lacquer, just be careful not to open the hole up otherwise the wire will be too loose then