xboxscene.org forums

OG Xbox Forums => Modchip Forums => Team Xodus Chips (Xenium) => Topic started by: outthere on September 08, 2004, 10:05:00 AM

Title: Bad Chip?
Post by: outthere on September 08, 2004, 10:05:00 AM
I thought i might add that i have the solderless and ver 1.0. I also cleaned the connections with alcohol
Title: Bad Chip?
Post by: dbldown768 on September 08, 2004, 10:10:00 AM
reseat the connections... and if you try holding it with your hand when you turn it on then you dont have it locked down good enough.  The other problem is it sounds like your d0 is not hooked up right if it goes directly to your MS dash.
Title: Bad Chip?
Post by: outthere on September 08, 2004, 12:04:00 PM
ok i tried everything again from start..
i decided to take a picture for ya to see..
that is the right spot for d0 isnt it??My Webpage huh.gif
Title: Bad Chip?
Post by: dbldown768 on September 08, 2004, 01:00:00 PM
yes it looks like it for a v1.0.  I soldered mine in so i dont know if your just letting a wire rest in there.  but i know if it acts like if the chip is not there its most likely your D0
Title: Bad Chip?
Post by: appleguru on September 08, 2004, 05:16:00 PM
Make sre your chip is on the correct way...
Title: Bad Chip?
Post by: acemilo on September 08, 2004, 06:23:00 PM
Solder it in, the adapter is garbage.
Title: Bad Chip?
Post by: acemilo on September 08, 2004, 10:07:00 PM
I'm sorry then your just gonna have to deal with the pos adapter.
Title: Bad Chip?
Post by: bishop05 on September 09, 2004, 12:23:00 PM
You about 90% done, you should just solder the header pin in.  

beerchug.gif
Title: Bad Chip?
Post by: acemilo on September 09, 2004, 01:37:00 PM
Altho I wouldn't suggest a solder gun, they are too powerful.
Title: Bad Chip?
Post by: outthere on September 09, 2004, 08:28:00 PM
well i cant get all the solder out of the holes..
and i didnt mean a gun i used an iron
Title: Bad Chip?
Post by: acemilo on September 09, 2004, 08:59:00 PM
Try hitting it from the other side of the board.  Make sure to put a little bit of solder on the iron itself it will make the solder flow much better.  Putting a little flux on the points will also help.