QUOTE(P3ST4 @ Dec 26 2006, 12:44 AM)
what hole? the d0 hole, LPC hole?
im not sure i did it with all of them but im not sure which one i carved out too much.... is there a way to tell?
QUOTE(bucko @ Dec 26 2006, 06:47 AM)
moved this to the correct forum.
This isn't the correct forum at all. He's talking about installing the Spider 16 solderless adapter for the SmartXX.
If you have a board with resin on it, then you cannot install the Spider16. It's nearly impossible to clear out those holes enough to do so.
If the board still boots up, then you're best off soldering the chip in. It's really not as hard as it seems to do so.