xboxscene.org forums
OG Xbox Forums => Modchip Forums => Team SmartXX Chips (SmartXX) => Topic started by: steveo1978 on October 27, 2011, 06:03:00 PM
-
try grounding d0 and see what happens. I beleive if the chip was dead and eevrything was hooked up right then the xbox would just frag instead of booting to the dash. Just solder the d0 from the xbox motherboard to a grond on the motherboard (like the copper around the motherboard screw holes) If the xbox frags after doing that recheck the soldering on the lpc and chip.
-
OK thanks. I'll do that tonight. I had a feeling it was the D0 but its such a pain, I was hoping it was something else.
Gator
-
Thanks for the help. Bought an X2.6 and installed the pin header. Put the Smartxx chip on it. Now with the D0 not grounded, the Xbox starts just fine and sounds like its working, but there is no output to the tv. With the D0 grounded, it frags really bad, and I can't open the drive either way. At least I know the D0 is grounded proper like this time.
Gator
-
recheck/re-solder your LPC points...where you installed the pinheader.