Post by: Allegro1 on January 24, 2007, 08:53:00 AM
Post by: bammer85 on January 24, 2007, 11:13:00 AM
QUOTE(Allegro1 @ Jan 24 2007, 05:00 PM) 
Hopefully you put in on a header. Does the box boot up fine with the chip out? It should not boot at all until you press the power button (modded) or eject button (non-modded). You don't need to remove any more LPC holes than are needed to install the header. Whether a hole is filled with solder or not makes no electrical difference. Are you SURE you have the chip lined up with the right pins on the header?
Yeah I soldered the header in. I haven't tried it without the chip yet. Does it matter that the D0 and BT are soldered on if I take off the chip? The Bank switch is supposed to be near the back of the case right? I soldered the D0 underneath ran it through, and soldered it to the D0 plate on the chip. The same for the BT. I soldered one end to the plate on the chip and one end to the top Left if your looking at all four. I think I have them lined up right. I went just how the picture told me to do it. I followed directions exactly. Is there a chance that it is dead now?
Yeah but the power thing. It turns itself back on when I turn it off whether it be the eject or power button.