Post by: creg turner on June 19, 2006, 08:17:00 PM
Also, is your duox2 chip white or blue? The blues come preflashed, but the whites don't. Make sure you know what version you have before soldering. v1.6 requires more soldering than v1.0-v1.5. I think about 5 extra wires need soldering.
Post by: creg turner on June 19, 2006, 09:01:00 PM
With the white version, you will have to flash the BIOS yourself.
My bad.. Do not use that link. Go on Xbox-scene and click a tutorial to determine the xbox version. Basically the chip under your DVD drive.
Post by: XSOLJA on June 20, 2006, 02:11:00 AM
QUOTE
Side question: I put mortal kombat in my pc to see how big the cd was and it only says 13.8mb, why does this seem soo far off?
a pc dvd drive cant read xbox disks, the only thing it will read is the 13.8mb file, thats why.
Post by: Chancer on June 20, 2006, 11:15:00 AM
What stage exactly are you at now with the install, flashing etc?
Moving to Team Omega
Post by: Julius Pleaser on June 20, 2006, 08:45:00 PM
For the pinheader, make sure you are heading the metal ring and the pin with the iron and then meltin the solder against that and not against the iron.
For the D0, use the bottom D0 as it is bigger and much easier to work with.
BTW, what version do you have so we can gpive you more soldering advice.
Post by: Chancer on June 21, 2006, 02:34:00 PM
Post by: Chancer on June 21, 2006, 02:42:00 PM
Post by: danielmid on June 21, 2006, 07:06:00 PM
Post by: Chancer on June 22, 2006, 05:50:00 AM
QUOTE(danielmid @ Jun 22 2006, 02:13 AM) 
I thought the white duo x2s came with flashbios and cromwell pre-flashed?
Yes thats right, but he has not even got the chip in yet
Post by: danielmid on June 22, 2006, 09:49:00 PM
QUOTE(Chancer @ Jun 22 2006, 04:57 AM)
Yes thats right, but he has not even got the chip in yet
Just clearing up some mis-information from earlier in the post. Thanks for the veification.
Post by: sycho on June 26, 2006, 01:59:00 PM
and http://www.hackdabox.com/Duox2.html
they also give good trouble shooting pages.
Post by: _GhOsT_ on June 26, 2006, 02:23:00 PM
QUOTE(turbo82 @ Jun 23 2006, 05:54 PM)
ok the chip is in, but now it will not power on?
check your soldering job, make sure bt is connected
if the little led on the chip isnt flashing then you have not installed it correctly
Post by: turbo82 on June 26, 2006, 06:19:00 PM
Mine is a v1.6 and I followed this install.
http://www.hackdabox...x2_Install.html
Even if I didn't have every wire on the chip soldered, it should still turn on, right?
If I'm reading this correctly, if I have anything but a 1.6 I can just solder the pin header to the chip and do a d0 and a bt and that's it?
EDIT: wait a min. why does the BT connect to the back of the eject button on these directions: http://www.fixnchipz.co.uk/page9.html but on the other directions it shows an alternate point.