xboxscene.org forums

OG Xbox Forums => Modchip Forums => Team Omega Chips (DuoX) => Topic started by: antz1970 on October 15, 2005, 10:14:00 AM

Title: Duox2 White Chip With 1.6 Xb
Post by: antz1970 on October 15, 2005, 10:14:00 AM
dry.gif ) if your xbox is still fragging on both banks then your lpc soldering or rebuild is @ fault , did you use a rebuild pcb or did u use wires? , double check all your soldering make sure all connections are in the correct place and are shiny and clean ,go over your pin header connections again make sure u aint damaged any traces or have any solder splashes (also check your soldering on the female pin header on the chip  beerchug.gif , you also dont mention if the xbox boots ok when booting normally without chip enabled (quick press of power button i think)?  beerchug.gif
Title: Duox2 White Chip With 1.6 Xb
Post by: HackDaBox on October 17, 2005, 06:32:00 AM

Couldn't of said it better my self !

HackDaBox !

Title: Duox2 White Chip With 1.6 Xb
Post by: HackDaBox on October 20, 2005, 01:35:00 AM

Yes it makes a difference ! You have to use the normal stock cables to flash your bios. Put the original cables in and you will see your chip is working fine !

Flash your bios and then you can change cables.

Flash with Evox M8 Plus V16 ( 512k )

HackDaBox !

PS try booting from bank 1 first but if it fails then try bank 0

Title: Duox2 White Chip With 1.6 Xb
Post by: jcupp114 on October 20, 2005, 04:15:00 AM
I have a simular case 1.6 with dead hard drive. lpc is build and works with chip off yet with chip on board I get no video and no sound yet the system does not frag. Im using the original av cord. Im using the sunday chips for the mods. Take care
jcupp114